Product Features
- High strength, good adhesion and wear resistance
- Acid and alkali resistance and all kinds of chemical corrosion
- Excellent waterproof and insulation performance
- Excellent flame retardant performance, UL94V-0
- Cold and hot shock resistance good capacitance
- Good weathering and aging resistance
Applications
- Waterproof insulation and anti-corrosion of cable intermediate joint;
- Switch cabinet insulation waterproof anti-corrosion
- Repair of medium and high voltage cable skin and waterproof and anti-corrosion
- Waterproof insulation treatment for middle and low pressure wire clip;
Technical Parameters
|
No. |
Test Item |
Typical Value |
Test Standards |
|
1 |
Flame resistance |
V-0 |
UL94 |
|
2 |
Post-cure hardness |
75 |
ASTM D 2240 |
|
3 |
Breakdown voltage |
1, 0.3mm thick coating: 10.4kV 2, 0.8mm thick coating: 24.4kV |
ASTM D 149 |
|
4 |
Wear resistance |
Weight lossat 1000 revolutions: < 0.040mg |
ASTM D 4060 |
|
5 |
Elongation at break |
30% (after curing) |
ASTM D 412 |
|
6 |
Resistance to salt fog |
5000 h without defect |
ASTM B 117 |
|
7 |
Cold and hot shock test |
after 100 cycles of cold and hot shock at- 40℃ and 85℃, t no defect |
ASTM D 1211 |
Direction for Use
1. Clean surface and keep dry;
2. Mix A and B according to 4:1 and stir well;
3. The protected surface can be evenly brushed, in general, brushing once can achieve the effect;
4. If the requirements are strict, can be in the first time after the table dry, besmear second times;
5. The complete curing time of the product is 60min~70min.
Package
1L / set (including A material 780ml, B material 220 ml)
100ml / set (including A material 78ml, B material 22 ml)
