EPR High Voltage Insulation Tape KC71

◆ Can be used to splice and terminate cable, the emergency overload temperatures can reach 130℃.

◆ Based on Ethylene Propylene Rubber(EPR).

◆ Physical and electrical properties are unaffected by the degree of stretch.

◆ Self-fusing tape.

◆ Excellent electrical properties.

◆ A special polyester liner which will not stick to the tape upon unwind.

◆ Operation and installation easily.

◆ Compatible with all solid dielectric cable insulation:

Polyethylene (high and low density).

Cross-linked polyethylene (XLPE).

Polyvinyl chloride (PVC).

Butyl rubber.

Inquiry now

product introduction

Product Description

Cotran Brand KC71 EPR High Voltage Insulation Tape is a highly conformable, self-fusing ethylene propylene

rubber(EPR), high insulting tape. KC71 is used for main insulation applications of cableand other electrical devices up to69KV.

Applications

◆ Electrical insulation jacketing in splices of solid dielectric cable up to 69kV.

◆ Building stress cones in terminations of solid dielectric cable up to 35kV.

◆ Jacketing of indoor terminations.

◆ Moisture sealing electrical connections.

◆ Bus bar insulations and corrosion protection.

◆ End sealing high-voltage cables.

◆ Jacket repair and restoration in all types of cable.

Test Parameters

No.	Test Item	Typical Value	Test Method
1	Color	Black	Visual
2	Thickness	0.76mm	ASTM D4325
3	Tensile Strength	2.3MPa	ASTM D4325
4	Elongation at Break	750%	ASTM D4325
5	Dielectric Strength	32KV/mm	ASTM D1000
6	Volume resistivity	6.2x1014Ώ.cm	ASTM-D4325
7	Fusion	Pass	ASTM D4388
8	Heat ageing(130℃ 168H)	Pass	ASTM D4325
9	UVageing	Pass	ASTM D4325
10	Xenon ageing	Pass	ISO 4892-2

Installation

Cotran Brand KC71 EPR High Voltage Insulation Tape should be applied in successive half-lapped, level-wound layers until desired build-up is reached.

Step 1 Perform normal cable preparation, and remove separator from tape;

Step 2 Apply tape half-lapped, stretching the tape 100%, which is enough to reduce its width to around 2/3 of its original width;

Step 3 Finish breaking the tape by holding it with your thumb and stick the end well.

Leave A Message

If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.

Subject : EPR High Voltage Insulation Tape KC71

Tags :

Related products

EPR Electrical Semi-conducting Tape KC72

◆ Can be used to repair XLPE cable terminations and joints or shielding for other devices up to 110kV.

◆ Retains its conductivity when stretched.

◆ Semi-conducting (low resistivity).

◆ Suitable for irregular shapes cable with good elongation.

◆ Withstand high temperatures (130°C/266°F) short-term overload.

◆ Compatible with all solid dielectric cable insulations and conductors.

◆ Resistance to ozone, solvents, UV, xenon exposure and moisture.

◆ Suitable for indoor or outdoor applications.

◆ Operation and installation easily.

◆ Increases its conductance and will not harm it in any way.

COTRAN Z551 Self-Fusing Silicon Rubber Tape

COTRAN Z551 self-fusing silicon rubber tape is composed of self-fusing silicone rubber and easily removed liner. It has excellent resistance to tracking, ozone, UV, corrosion, water and continuous operating temperature of -50℃～180℃. It can be used in dirty areas. Suitable for busbar insulation protection and phase identification, Insulation for terminations and joints of high-voltage power cables up to 35kV, Insulation for submarine cables, submersible motors, large-sized generators, automobiles, aero engines and other electrical equipment.

64/110kv YJZWFY Outdoor Termination with Composite Insulator For 64/110kv Xlpe Cable

Composite sheath has many advantages compared with traditional porcelain sheath, so it is the best substitute and has been accepted gradually all over the world.

Heat shrink cable accessories 1KV

Cotran heat shrink terminations and joints are composed of a series of pre-expanded adhesive lined heat shrink tubes and necessary accessories. Heat shrink and provide excellent waterproof seal and electrical insulation. The terminations and joints are designed to be suitable for SWA/UA, XLPE/PVC/PILC, S/C, multi-core cable rated to 0.6/1kV.

Constant Force Spring Terminations Parts Spring Roll

Applications：

It's used for fixing the shielding of low voltage and medium voltage cable joints and terminations.

64/110KV YJZWGG Pre-Fabricated Dry Outdoor Termination For 64/110kv Xlpe Cable

Pre-fabricated dry termination is integrally composited of stress cone and silicone rubber insulation material.

Electrical Insulation Waterproof Vinyl Mastic Tape KC75

KC75 is a self-fusing, conformable, vinyl backing mastic tape. KC75 seals out moisture and protects against corrosion without the need for heating tools or using multiple tapes. KC75 is designed for cable sheath repair, low voltage insulating, conduit repair and protection of CATV components as well as other general taping applications. Application Electrostatic shielding solid dielectric cable connector and terminal Filling all kinds of irregular joint Repair of high-voltage connector conductor shielding layer Other shielding occasions Technical Data Property Typical Value Test Method Adhesion to steel 18.7N/10mm ASTM D 1000 Adhesion to PE 20.2N/10mm ASTM D 1000 Dielectric strength 21KV/mm ASTM D 4325 Volume Resistivity 1.66*10^34 Ω ASTM D 1000 Water Absorption 0.2% ASTM D 4325 Packing Part No. Dimension Color Rolls/Case KC75 38mm*0.635mm*6m Black 40 Note: Other size is available on request.