Anticorrosive Coating for Towers

Anticorrosive coating for towers is a two-component, thick-type, one-side polyurethane acrylic coating with excellent weather resistance and long recoating performance. This product has both anti-corrosion, weather resistance in one, with excellent wear resistance, impact resistance, color retention and aging resistance.

Inquiry now

product introduction

Product Features

The construction is safe and convenient, and the surface treatment requirements are low

Primer painting and finished painting designing into one, cost-effective, save labor and materials

Environmental friendly and pollution-free, in line with the international environmental protection requirements

Applications

Anticorrosion protection of steel tower structure in new construction or maintenance
Anticorrosion protection of other steel structures in various corrosive environment

Technical Parameters

Test Item	Test Standards	Typical Value
Appearance	JG/T 224-2007	Gray
Solid content, (%)	GB1725-79	55
surface dry,（h）	GB/T 1728–1979(1989)	1.5
Entity dry,（h）	GB/T 1728–1979(1989)	5.5
Adhesion (grid method/grade)	GB/T 9286-98	0
Bending resistance (mm)	JG/T 224-2007	2
Impact resistance (mm)	JG/T 224-2007	40
Resistance to water	GB1733-93	168h no abnormalities
Aging test	JG/T 224-2007	no crack, powder ≤ level 1; Discolor≤ level 2
Resistance to salt spray	JG/T 224-2007	750h no flake no red rust
Acid resistance (5%H2SO4)	JG/T 224-2007	500h without exception
Salt resistance water (3%NaCl)	JG/T 224-2007	500h without exception
Workability.	JG/T 224-2007	Brush two lines without obstacles
Environmental performance	RoHS 2.0	Qualified

Direction for Use

1, Surface treatment: Clean up rust, burr, oil, dust, the surface should be flat, dry, no loose floating rust, old coating film, oxide scale, rust removal grade should reach ST2 level and above.

2, A, B components in accordance with the use of the proportion of mixing, stirring uniform can be constructed, according to different construction methods and site environmental conditions in the paint to add the appropriate amount of diluent deployment to the appropriate viscosity, so that the paint can be fully infiltrated but does not produce leakage, hanging, loose, peeling and other defects.

3, The tower site coating construction should be carried out from top to bottom. The coating method can be applied by brushing or spraying.

Product Specification

21kg / set (including component A 17.5kg/barrel, component B 3.5kg/barrel)

3kg / set (including component A 2.5kg/ barrel, component B 0.5kg/barrel)

Certificate

Leave A Message

If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.

Subject : Anticorrosive Coating for Towers

Tags :

Related products

Visco-Elastic Self-adhesive Corrosion Protection Tape

Viscoelastic Anti-Corrosion Adhesive Tape

The viscoelastic anti-corrosion adhesive tape is an ideal anti-corrosion product. Widely used in corrosion prevention and repair of the anti-corrosion coating of oil and natural gas pipelines, repair of damaged 3PE anti-corrosion coating, and corrosion protection of irregular equipment such as flanges, valves and pumps. It has unique cold flow property and can repair itself during anti-corrosion and repairing process to achieve complete protection. Due to the excellent chemical resistance and no peel-off of the cathodic protection layer, the product can completely eliminate water intrusion and microbial corrosion and thus ensure unique long-term effect.

PE Anti-Corrosion Adhesive Tape

PE anticorrosive adhesive tape is mainly used in oil and gas transmission; Chemical industry, urban construction of water supply and drainage and gas transmission, etc. The outer surface of the buried steel pipeline corrosion. Construction is convenient, no pollution and other characteristics, is outside the pipe anticorrosion priority of anticorrosive system. The performance indicators of the product fully meet the provisions of CNPCstandard SY/T0414-2017 and American Industrial Association standards ANSI/AWWAC209-00 and NACEMR0274-95. The product has reached the level of similar products at home and abroad.

Primer for Anti-Corrosion Tape

The anticorrosive primer and PE anticorrosive tape together constitute the polyethylene cold wound anticorrosive system. Coated on the surface treatment of steel tube, can fill a small bump on the surface of the steel tube, and can increase the adhesive tape with sticky relay between steel tube, at the same time it is also a kind of excellent corrosion inhibitor.

KC58 Epoxy Glass Fiber Electrical insulating Tape

KC58 epoxy glass fiber electrical insulating tape is a strip of insulating binding material of a certain width, impregnated with a high temperature heat curing epoxy resin by a unidirectional, continuous twist, alkali-free glass fiber yarn after treatment. This tape has good softness and viscosity, opened in a network structure, easy to roll back, no loose wire, no overlap. The product has high strength, impact resistance, high modulus, low elongation, no hysteresis and no eddy current loss and other excellent properties.

COTRAN FEP 200℃ Temperature Resistant FEP Heat Shrinkable Tubing

FEP heat shrinkable tubing is made of FEP with excellent 200℃ high-temperature performance, chemical resistance, high insulation and excellent mechanical properties. FEP has excellent abration resistance and excellent clarity. Designed to provide insulation and mechanical protection in severe chemical and thermal environments. Widely used in electronic, aerospace, military and communication fields.

TPO SEALING TAPE

Product Description

TPO sealing tape combines both polypropylene(plastic) and ethylene-propylene (rubber)using state-of-the-art extruding manufacturing technology, which exhibits excellent versatile physical properties of plastic and rubber. Featured with pliable and weldable properties, COTRAN TPO delivers its unique high elasticity under normal condition and its superior plasticity under extreme temperature. Therefore its excellent physical and chemical parameters(high tensile strength and elongation) forges its unbeatable quality.Being commercial roofing system that is reliable, cost effective,environmentally friendly and easy to install, COTRAN TPO is mostly suited for single ply light steel roofs.

KC9229 Acrylic Foam Tape

KC9229 acrylic foam tape is a kind of high viscosity fully closed hole acrylic tape made of special acrylic adhesive process. Fully closed cell structure and viscoelasticity give this tape, moisture-proof, water-proof, dust-proof, shock absorption, sound insulation, joint filling and other effects, plastic, metal, wood, paper and silicone and other difficult to stick, uneven surface has a good adhesive effect.

The product maintains good durability in high, low temperature and high temperature and high humidity environment; Excellent adhesion fixing effect for high and low surface energy materials.