Metal Shielding Mesh Tape for Power Cable KC84

Applications：

Recommended for applications both in open air and underground power distribution cables with PVC ,lead or XLPE sheaths.

◆Excellent surface flatness

◆Large thermal transfer area

◆Flexible flow channel design

◆Easy processing and shaping

◆Good thermal dissipation effect

◆Low leakage risk and high safety

◆Good pressure resist and strength

◆High production efficiency and yield

The shear bolt connectors are intended for stranded and solid aluminum and copper cable, low voltage and medium voltage up to 36 kV.

They comprise cable areas 10-400 mm² even bigger for sector cable. There is also a screw sleeve for branches up to a total of 100 mm². The joint with the conductor is achieved by the screws in the connector or terminal being tightened to a predetermined torque.

Cotran wraparound repair sleeve (CWRS) is designed to repair damaged cable jackets and protect cable or pipes where needs corrosion protection on undamaged ones. CWRS is made from modified cross-linked polyolefin (XLPE) with a hot-melt adhesive. When heating, the sleeve shrinks and the adhesive melts, thereby achieving tightly bonding between the sleeve and the cable. It provides an excellent solution of protection against mechanical stress, harshest environments, moisture and corrosion.

CWRF is a fiber reinforced repair sleeve, which is composed of XLPE and fiber layer. It can provide better mechanical properties. CWRA is a fiber reinforced and aluminum layer reinforced repair sleeve, which is composed of XLPE, fiber layer, and aluminum layer. It can provide more stronger mechanical properties than CWRS and CWRF.

◆IPX8 class, stable and long-life during operation

◆Easy to install, only two steps (Cover, pull)

◆Fast installation, only 15-30 seconds needed to seal one connection

◆No limitation of spare space, especially design for MIMO &massive MIMO Antenna, also convenient to deploy on wall-mounted, high tower, pole-mounted condition etc.,

◆Easy to uninstall, only need knife to cut tube open

◆No skill required by engineers, uniform quality after installation, stable and good sealing and weatherproofing performance

◆Much time cost, and labor cost saving

◆Good operating capability under extreme cold and hot condition, highland, salt-mist situation, heavy windy weather, and anti-UV, anti-ozone

Designed for insulation of copper and aluminum busbars- for electrical substations and switchgear cabinets. Can be used for exterior installations

Shrink ratio: 2.5:1

Operating voltage: 35 kV

Material: polyolefin, halogen-free «HF»

Analogs: BPTM (Raychem); BBI (3M)

Resistant to the phenomenon of tracking and UV radiation

High dielectric strength

Color: brick red

The use of tubes ТТШ allows shortening the distance between phase busbars and significantly reducing the dimensions of the device

Protects electrical busbars against chemical corrosion

Protects equipment from short circuits in case of contact of electrical devices with animals and birds

◆High material utilization

◆Battery side heat dissipation

◆Large thermal dissipation area

◆High thermal dissipation efficiency

◆Low leakage risk and high reliability

◆Stable and high production efficiency

◆Reduce the weight of the battery pack

◆Improve the battery life and performance

Termination with porcelain insulator is mainly comprised of porcelain sheath, stress cone, tail pipe, supporting insulator, lug and other accessories. Porcelain sheath has the structure of high strength electrical porcelain and rain-shed of different sizes. It is with good antipollution flashover performance and the porcelain sheath is filled with polyisobutene. This product has mature operational experience and reliable quality.