Stress Release Mastic Tape KC100

◆Excellent surface flatness

◆Large thermal transfer area

◆Flexible flow channel design

◆Easy processing and shaping

◆Good thermal dissipation effect

◆Low leakage risk and high safety

◆Good pressure resist and strength

◆High production efficiency and yield

◆High production efficiency

◆Good heat exchange effect

◆Large thermal transfer area

◆High performance cost ratio

◆Rapid thermal cooling speed

◆Thin thickness to save space

◆Easy processing and shaping

◆Low leak risk and high security

◆Large thermal dissipation area

◆High thermal dissipation efficiency

◆Low leakage risk and high reliability

◆Stable and high production efficiency

◆Reduce the weight of the battery pack

◆Low energy for single cylindrical battery

◆Improve the battery life and performance

◆Less pollution and environmental protection

◆High production efficiency

◆Large thermal transfer area

◆High performance cost ratio

◆Rapid thermal cooling speed

◆Thin thickness to save space

◆Easy processing and shaping

◆Good thermal exchange effect

◆Low leak risk and high reliability

PE anticorrosive adhesive tape is mainly used in oil and gas transmission; Chemical industry, urban construction of water supply and drainage and gas transmission, etc. The outer surface of the buried steel pipeline corrosion. Construction is convenient, no pollution and other characteristics, is outside the pipe anticorrosion priority of anticorrosive system. The performance indicators of the product fully meet the provisions of CNPCstandard SY/T0414-2017 and American Industrial Association standards ANSI/AWWAC209-00 and NACEMR0274-95. The product has reached the level of similar products at home and abroad.

1. The body of joint is made of imported silicone rubber with good quality, so it is with high strength, elasticity and tear resistance as well as excellent thermal

aging resistance.

2. The body of joint has integral pre-fabricate structure with high voltage shielded, stress cone and insulating injection pressed integration, so it has excellent properties and easy to test as well as install.

3. The body of joint is analized and computed optimization by finite element software, so it has more resonable field-intensity distribution and high insulation safety margin.

4. The body of insulating joint and straight through joint is the same, the d ifference is just the handling of shielding on-site installation, insulating joint with one side insulated and the rest shielded while staight through joint full shielded.

5. The joint has completely sealed structure with high mechanical strength and good sealing performance.

6. Joint protecting is made of insulating copper case with high-intensitive T2 copper, and the moulded high-density PE material of its external surface is used for insulation and anti-corrosion with good mechanical protection and permanent waterproof sealing performance, which ensure the joint to run safely and reliably in the long-term under harsh environment.In addition, it can equip glass fiber reinforced plastic protective box as a strengthen waterproof measure accordingly.

7. Special installer tools make the installation more convenient.

Dry GIS termination has composite structure of stress cone and epoxy sheath, making the surface of pre-fabricated stress cone clinged to the inner wall of epoxy sheath through spring assembly to reach reasonable interface pressure.

◆ High tensile strength and bonding strength.
◆ Suitable for irregular shapes cable with good elongation.
◆ Ensuring high quality seal over a wide range of temperatures.
◆ Physical and electrical properties are unaffected by the degree of stretch.
◆ Self-fusing tape.
◆ Good chemical resistance, weather resistance and corrosion resistance.
◆ Excellent ageing properties.
◆ Excellent electrical properties.
◆ Operation and installation easily.