Industrial Electrical Fiberglass Armor Tape KC88

◆Easy to install, only two steps (Cover, pull)

◆Fast installation, only 15-30 seconds needed to seal one connection

◆No limitation of spare space, especially design for MIMO &massive MIMO Antenna, also convenient to deploy on wall-mounted, high tower, pole-mounted condition etc.,

◆Easy to uninstall, only need knife to cut tube open

◆No skill required by engineers, uniform quality after installation, stable and good sealing and weatherproofing performance

◆Much time cost, and labor cost saving

◆Good operating capability under extreme cold and hot condition, highland, salt-mist situation, heavy windy weather, and anti-UV, anti-ozone

◆ Can be used to splice and terminate cable, the emergency overload temperatures can reach 130℃.

◆ Based on Ethylene Propylene Rubber(EPR).

◆ Physical and electrical properties are unaffected by the degree of stretch.

◆ Self-fusing tape.

◆ Excellent electrical properties.

◆ A special polyester liner which will not stick to the tape upon unwind.

◆ Operation and installation easily.

◆ Compatible with all solid dielectric cable insulation:

Polyethylene (high and low density).

Cross-linked polyethylene (XLPE).

Polyvinyl chloride (PVC).

Butyl rubber.

◆High processing efficiency

◆Lower energy consumption

◆Large thermal transfer area

◆Rapid thermal cooling speed

◆Thin thickness to save space

◆Excellent thermal performance

◆Low leak risk and high reliability

◆Good tightness and high strength

◆Large thermal dissipation area

◆Battery side thermal dissipation

◆High thermal dissipation efficiency

◆Low leakage risk and high reliability

◆Stable and high production efficiency

◆Reduce the weight of the battery pack

◆Low energy for single cylindrical battery

◆Improve the battery life and performance

Designed for insulation of copper and aluminum busbars- for electrical substations and switchgear cabinets. Can be used for exterior installations

Shrink ratio: 2.5:1

Operating voltage: 35 kV

Material: polyolefin, halogen-free «HF»

Analogs: BPTM (Raychem); BBI (3M)

Resistant to the phenomenon of tracking and UV radiation

High dielectric strength

Color: brick red

The use of tubes ТТШ allows shortening the distance between phase busbars and significantly reducing the dimensions of the device

Protects electrical busbars against chemical corrosion

Protects equipment from short circuits in case of contact of electrical devices with animals and birds

Cotran wraparound repair sleeve (CWRS) is designed to repair damaged cable jackets and protect cable or pipes where needs corrosion protection on undamaged ones. CWRS is made from modified cross-linked polyolefin (XLPE) with a hot-melt adhesive. When heating, the sleeve shrinks and the adhesive melts, thereby achieving tightly bonding between the sleeve and the cable. It provides an excellent solution of protection against mechanical stress, harshest environments, moisture and corrosion.

CWRF is a fiber reinforced repair sleeve, which is composed of XLPE and fiber layer. It can provide better mechanical properties. CWRA is a fiber reinforced and aluminum layer reinforced repair sleeve, which is composed of XLPE, fiber layer, and aluminum layer. It can provide more stronger mechanical properties than CWRS and CWRF.