Heat Resistant Silicone Rubber Electrical Tape KC73

◆IPX8 class, stable and long-life during operation

◆Easy to install, only two steps (Cover, pull)

◆Fast installation, only 15-30 seconds needed to seal one connection

◆No limitation of spare space, especially design for MIMO &massive MIMO Antenna, also convenient to deploy on wall-mounted, high tower, pole-mounted condition etc.,

◆Easy to uninstall, only need knife to cut tube open

◆No skill required by engineers, uniform quality after installation, stable and good sealing and weatherproofing performance

◆Much time cost, and labor cost saving

◆Good operating capability under extreme cold and hot condition, highland, salt-mist situation, heavy windy weather, and anti-UV, anti-ozone

◆Large thermal dissipation area

◆High thermal dissipation efficiency

◆Low leakage risk and high reliability

◆Stable and high production efficiency

◆Reduce the weight of the battery pack

◆Low energy for single cylindrical battery

◆Improve the battery life and performance

◆Less pollution and environmental protection

◆High production efficiency

◆Large thermal transfer area

◆High performance cost ratio

◆Rapid thermal cooling speed

◆Thin thickness to save space

◆Easy processing and shaping

◆Good thermal exchange effect

◆Low leak risk and high reliability

The anticorrosive primer and PE anticorrosive tape together constitute the polyethylene cold wound anticorrosive system. Coated on the surface treatment of steel tube, can fill a small bump on the surface of the steel tube, and can increase the adhesive tape with sticky relay between steel tube, at the same time it is also a kind of excellent corrosion inhibitor.

◆High production efficiency

◆Large thermal contact area

◆Uniform and stable welding

◆Rapid thermal cooling speed

◆Thin thickness to save space

◆Easy processing and shaping

◆Good thermal exchange effect

◆Low leak risk and high security

◆High processing efficiency

◆Lower energy consumption

◆Large thermal transfer area

◆Rapid thermal cooling speed

◆Thin thickness to save space

◆Excellent thermal performance

◆Low leak risk and high reliability

◆Good tightness and high strength

◆High production efficiency

◆Good heat exchange effect

◆Large thermal transfer area

◆High performance cost ratio

◆Rapid thermal cooling speed

◆Thin thickness to save space

◆Easy processing and shaping

◆Low leak risk and highsecurity

Material and Plating Inner Conductor Pin Brass / Silver Plating Inner Conductor Socket Tin Bronze / Silver Plating Insulator TPX Body & Outer Conductor Brass / Trimetal Plating Gasket Silicon Rubber Electrical Specifications Characteristics Impedance 50 Ohm Frequency Range DC~2.7GHz Insulation Resistance ≥5000MΩ Dielectric Withstanding Voltage 2500V rms Operating Voltage 1400V rms Center contact resistance ≤1.5 mΩ Outer contact resistance ≤1.5mΩ Insertion Loss @DC-2.7 GHz ≤0.10dB VSWR @0.8-1.0 GHz ≤1.08 @1.7-2.7 GHz ≤1.13 PIM3(2*43dBm) ≤-155dBc Environmental & Mechanical Specifications Durability (matings) ≥500 cycles Mechanical Shock Test Method MIL-STD-202, Method 213, Test Condition D Vibration Test Method MIL-STD-202, Meth. 204, Cond. A Temperature Range -65°C to +85°C RoHS Compliant Sealing Class IP68 24hr, 1m, 20℃ Regulatory Compliance / Certification ISO 9001:2015 Compliant The facts and figures contained herein are carefully complied to the best of our knowledge, but they are intended for general informational purposes only.