Heat Resistant Silicone Rubber Electrical Tape KC73

The shear bolt connectors are intended for stranded and solid aluminum and copper cable, low voltage and medium voltage up to 36 kV.

They comprise cable areas 10-400 mm² even bigger for sector cable. There is also a screw sleeve for branches up to a total of 100 mm². The joint with the conductor is achieved by the screws in the connector or terminal being tightened to a predetermined torque.

Special designed to meet the requirements of high performance identification of wire and cable. It is made of superior flame retardant polyolefin with excellent electrical, physical, chemical and printing properties. Permanent printing property can be widely used for high-performance identification of wire and cables in industrial, military, aerospace, etc.

◆Uniform and stable welding

◆Rapid thermal cooling speed

◆Thin thickness to save space

◆Easy processing and shaping

◆Good thermal exchange effect

◆Low leak risk and high security

◆Less pollution and environmental

◆Improve the battery performance

◆High processing efficiency

◆Good welding performance

◆Large thermal transfer area

◆High tightness and strength

◆Flexible flow channel design

◆Rapid thermal cooling speed

◆Thin thickness to save space

◆Good thermal exchange effect

Designed for insulation of copper and aluminum busbars- for electrical substations and switchgear cabinets. Can be used for exterior installations

Shrink ratio: 2.5:1

Operating voltage: 35 kV

Material: polyolefin, halogen-free «HF»

Analogs: BPTM (Raychem); BBI (3M)

Resistant to the phenomenon of tracking and UV radiation

High dielectric strength

Color: brick red

The use of tubes ТТШ allows shortening the distance between phase busbars and significantly reducing the dimensions of the device

Protects electrical busbars against chemical corrosion

Protects equipment from short circuits in case of contact of electrical devices with animals and birds

COTRAN tornado X526 light insulation material is a self-curing insulating coating material for robot coating. The coating material can be quickly constructed and cured at room temperature. After curing, it has good insulation properties, ultraviolet resistance, strong adhesion, mechanical wear resistance and heat resistance.

The robot coating device is composed of walking module, coating module and wireless control system. It can carry out automatic insulation treatment for 35kV and below overhead bare wires, and can work with live line, automatic up and down line, safe construction, convenient and efficient. After processing, it can effectively prevent insulation hazards such as tree barriers, small animal contact, and external short circuit, and improve the reliability of the power supply of the distribution network.

Cotran heat shrink terminations (indoor/outdoor) are precisely designed to meet the parameters of international cable and cable accessories standards such as CENELEC HD 629.1 S1, IEEE-48, IEEE-404, IEC60502. Our heat shrink terminations offers reliable and consistent performance for longer service life. We have designed our heat shrink terminations for single core and 3 cores extruded UA, SWA/STA, CWS/CTW cable through 36KV.

Product Introduction

Made from specially formulated radiation cross-linked compounds. It can provide high resistance to tracking and arcing. Used to enhance the insulation properties of busbar in switch and substation to safe protect up to safe protect up to 11 kv, 24kv, 36kv.