Cold Shrink 3 cores cable Breakout (1~36kV)

Cotran cold shrink terminations and joints are composed of a series of pre-expanded silicone tubes and necessary accessories. The core is removed after the tube is positioned for installation over an inline connection, or terminal lug, allowing the tube to shrink and provide a excellent waterproof seal and electrical insulation. The terminations and joints are designed to be suitable for SWA/UA, XLPE/PVC, Single-core and multi-core cable rated to 0.6/1kV.

Cotran cold shrink terminations (indoor/outdoor) are precisely designed to meet the parameters of international cable and cable accessories standards such as CENELEC HD 629.1 S1, IEEE-48 class 1, IEEE-404, IEC60502. Our cold shrink terminations offers reliable and consistent performance for longer service life. We have designed our cold shrink terminations for single core and 3 cores extruded UA, SWA/STA, CWS/CTW cable through 36kV.

Special designed to meet the requirements of high performance identification of wire and cable. It is made of superior flame retardant polyolefin with excellent electrical, physical, chemical and printing properties. Permanent printing property can be widely used for high-performance identification of wire and cables in industrial, military, aerospace, etc.

◆ Continuous waterproofing.

◆ Highly self-fusing tape.

◆ Suitable for irregular shapes cable.

◆ Resistance to high/low temperature.

◆ Resistance to corrosion.

◆ Resistance to ozone, UV, xenon exposure.

◆ New formulation for insulation.

◆ Operation and installation easily.

◆ Excellent adhesion to copper, aluminum and cable jacket.

Product introduction

Made of modified radiation crosslinked elastomer, it has excellent resistance to diesel oil, chemical agents, high temperature fluids, long-term heat resistance and wear resistance. It is used for the protection of military or automotive cable terminals, separation joints, etc., and the working temperature range of the cable harness is wide, and the environment of diesel, aviation fuel, hydraulic oil, lubricating oil and other fluids is required.

The inflatable duct sealing system (IDSS) is a wraparound, inflatable mastic-lined bladder used to seal empty or filled cable ducts. When inflated to proper air pressure, the IDSS seals the duct, guaranteeing a reliable water block. The IDSS can be installed in cable ducts in manhole, vaults, buildings, cabinets, or anywhere a reliable duct seal is needed. Application include ducts containing multiple copper, coax, or fiber cable, customer premise cable entrance, and air pipes. IDSS can be installed between -40℃ to 75℃.

◆Large thermal dissipation area

◆Good tightness and high strength

◆High thermal dissipation efficiency

◆Low leakage risk and high reliability

◆Stable and high production efficiency

◆Reduce the weight of the battery pack

◆Improve the battery life and performance

◆Less pollution and environmental protection

COTRAN tornado X526 light insulation material is a self-curing insulating coating material for robot coating. The coating material can be quickly constructed and cured at room temperature. After curing, it has good insulation properties, ultraviolet resistance, strong adhesion, mechanical wear resistance and heat resistance.

The robot coating device is composed of walking module, coating module and wireless control system. It can carry out automatic insulation treatment for 35kV and below overhead bare wires, and can work with live line, automatic up and down line, safe construction, convenient and efficient. After processing, it can effectively prevent insulation hazards such as tree barriers, small animal contact, and external short circuit, and improve the reliability of the power supply of the distribution network.