Stress Release Mastic Tape KC100

Applications：

Cable Connector are applicable to connect the circular wires and cables. GT series of copper connectors are used for copper cable connections, GL series of aluminum connectors are used for aluminum cable connections.

1. The body of joint is made of imported silicone rubber with good quality, so it is with high strength, elasticity and tear resistance as well as excellent thermal

aging resistance.

2. The body of joint has integral pre-fabricate structure with high voltage shielded, stress cone and insulating injection pressed integration, so it has excellent properties and easy to test as well as install.

3. The body of joint is analized and computed optimization by finite element software, so it has more resonable field-intensity distribution and high insulation safety margin.

4. The body of insulating joint and straight through joint is the same, the d ifference is just the handling of shielding on-site installation, insulating joint with one side insulated and the rest shielded while staight through joint full shielded.

5. The joint has completely sealed structure with high mechanical strength and good sealing performance.

6. Joint protecting is made of insulating copper case with high-intensitive T2 copper, and the moulded high-density PE material of its external surface is used for insulation and anti-corrosion with good mechanical protection and permanent waterproof sealing performance, which ensure the joint to run safely and reliably in the long-term under harsh environment.In addition, it can equip glass fiber reinforced plastic protective box as a strengthen waterproof measure accordingly.

7. Special installer tools make the installation more convenient.

Composite sheath has many advantages compared with traditional porcelain sheath, so it is the best substitute and has been accepted gradually all over the world.

Termination with porcelain insulator is mainly comprised of porcelain sheath, stress cone, tail pipe, supporting insulator, lug and other accessories. Porcelain sheath has the structure of high strength electrical porcelain and rain-shed of different sizes. It is with good antipollution flashover performance and the porcelain sheath is filled with polyisobutene. This product has mature operational experience and reliable quality.

The shear bolt connectors are intended for stranded and solid aluminum and copper cable, low voltage and medium voltage up to 36 kV.

They comprise cable areas 10-400 mm² even bigger for sector cable. There is also a screw sleeve for branches up to a total of 100 mm². The joint with the conductor is achieved by the screws in the connector or terminal being tightened to a predetermined torque.

Applications：

Used to provide insulation protection for cable termination and straight joint.

Designed for insulation of copper and aluminum busbars- for electrical substations and switchgear cabinets. Can be used for exterior installations

Shrink ratio: 2.5:1

Operating voltage: 35 kV

Material: polyolefin, halogen-free «HF»

Analogs: BPTM (Raychem); BBI (3M)

Resistant to the phenomenon of tracking and UV radiation

High dielectric strength

Color: brick red

The use of tubes ТТШ allows shortening the distance between phase busbars and significantly reducing the dimensions of the device

Protects electrical busbars against chemical corrosion

Protects equipment from short circuits in case of contact of electrical devices with animals and birds

◆ Continuous waterproofing.

◆ Highly self-fusing tape.

◆ Suitable for irregular shapes cable.

◆ Resistance to high/low temperature.

◆ Resistance to corrosion.

◆ Resistance to ozone, UV, xenon exposure.

◆ New formulation for insulation.

◆ Operation and installation easily.

◆ Excellent adhesion to copper, aluminum and cable jacket.